Virtually ANYTHING can be ripped on the FlexiRip:

• Solid wood, edged or unedged

• Glued panels

• Plywood, particle board and wood fiber composites

• Veneer, melamine and sheet insulation

• Aluminum and plastics

• And many other materials and substrates

More than just a panel saw, the FlexiRip can be used to rip or edge rough material and then cut an angle on panel stock with absolutely no changeover time. Can be used manually with a laser line to show the blade path or run pre-programmed rips or crosscuts with the automatically movable fence.

The simple touch screen interface can hold up to 100 rip or crosscut sizes that can be called up with a touch of the button. Multiple operators can select a certain size, or use the interface to set up programmed rip sequences using the movable fence for automatic positioning.

The FlexiRip can also be used for diagonal cuts and even beveled edges with compound angles! Pieces can be ripped either freehand with the laser guide line or a combination of cuts with the moving fence. You can edge the piece freehand and then just enter a desired width and rip the rest of the piece automatically.

Even partial rips are programmable. You can program the saw blade to rip a certain distance into the board, and crosscut to that same dimension, leaving a specified "notch" in the piece, even with angled cuts.

Table and fence extensions available for lengths up to 30 feet and widths up to 82 inches.

The ultimate in flexibility and safety for all your rip and crosscut needs.