The OptiCut S - Series from DIMTER:
The Universal Cross-cut Saws with the Large Performance Spectrum

Cross-cutting is done everywhere! And in cutting to length there is far more potential for increasing productivity than generally assumed. It does not matter whether it is a question of higher production capacity or increased profit by saving wood through higher yield and having higher value added.

The DIMTER OptiCut S-Series makes the advantages of cross-cutting also accessible to small and medium-sized plants in the woodworking industry.

Even the smallest one, the OptiCut S35, cuts up to four times as much as a manual cross-cut saw - with half as many employees*. Because the OptiCut carries out many process steps automatically.

• Transporting

• Exact positioning

• Safe clamping

• Cutting

*(User's statement)

In the meantime the employee loads the material and stacks the cut lengths away. Whether small or large production runs: DIMTER OptiCut always offers more! And this of course is done very safely, because the hands stay outside.

OptiCut S50

OptiCut S90

OptiCut S700

If preset lengths are cut according to a fixed cutting pattern, - e.g. when fixed batch sizes should be produced from "clear" raw timber quality - then the capacity can easily be multiplied. The workpieces are simply cut as a package. With this even large daily outputs are possible on a push-feed saw.

High flexibility guarantees the function "manual cutting". At any time a manual trim cut, a defect or lengths can be individually cut in between the production.

The OptiCut also offers the opportunity to cut lengths from a cutting list after the workpiece has been automatically measured - of course with the lowest waste.

An upgrading of the wood quality for higher value added and more can be achieved via the function "Cutting out the defects automatically". Afterwards the timber can be glued together again on a finger-jointing line to have a "defect-free" timber quality for further production.

Full optimizing is also possible: The OptiCut cuts off lengths from a cutting list between marked defects. The OptiCom software always calculates the best combination of lengths to reduce the waste and to upgrade the qualities. On the OptiCut S-series up to four qualities can be taken into consideration. By saving waste and qualitative upgrading the yield exceeds by far the possibilities of manual cross-cutting.

In spite of the large performance spectrum the OptiCut is operated very easily - just as easy as preparing a cutting list. Every OptiCut may be managed from the office as well and with the intuitive OptiCom Direct Touchscreen Terminal the saw can easily be integrated into your companies network. The operator only has to feed the machine and take care of the produced lengths. Fully automized solutions are also available according to the needs of your individual production.

The OptiCut is also open for the future development of your plant: Very many options can be retrofitted later on.